Skip to content
Call (505) 371-4111

Concrete Leveling Rio Rancho NM - Mudjacking & Polyjacking for Sunken Slabs

Concrete leveling in Rio Rancho lifts sunken sidewalk panels, driveway slabs, patios and garage aprons back into place without tearing them out.

Slab leveling equipment beside a sunken concrete panel next to a stucco house

When the slab is still in one piece, raising it is usually faster and cheaper than replacing it.

Request a site visit and itemized quote

Rather talk it through?

(505) 371-4111

Call anytime or send the form. Either way, you get a site visit and an itemized quote.

New concrete walkway and front steps leading to a stucco home with desert landscaping

Why Slabs Sink Here

A slab sinks when the ground under it compacts or washes out. In central New Mexico, a common cause is collapsible soil: the New Mexico Bureau of Geology and Mineral Resources describes soils that compact and settle after they get wet, often from roof runoff, leaking lines or road runoff. Downspouts that dump next to a walk, a sprinkler line that leaks under a patio, or a gap at the garage door that lets water under the driveway can all leave a void below the concrete. Leveling fills that void and lifts the slab; fixing the water source keeps it from coming back.

Worker running a plate compactor over a gravel base inside new forms, with the Sandia Mountains behind

Mudjacking

Mudjacking pumps a cement-based slurry under the slab through holes drilled in the concrete. As the slurry fills the void, it pushes the slab back up. The holes are then patched. HomeGuide's national 2026 range is $4 to $9 per square foot, and HomeGuide notes that many contractors charge minimum job fees of $300 to $700, which matters on small jobs like a single sidewalk panel.

Polyjacking

Polyjacking (also called foam jacking) injects expanding polyurethane foam through smaller holes. The foam is much lighter than slurry and cures quickly. HomeGuide prices polyjacking at $8 to $25 per square foot nationally and says it makes sense where minimal disruption, weak underlying soil, or appearance and fast cure time are priorities. On loose desert soils, a lighter fill puts less new weight on the ground that already settled.

Example illustration, not a photo of a completed project.

Walkway panel leveling
Example illustration: a sunken walkway panel with a raised trip edge beside a stucco houseExample illustration: the same panel lifted level with its neighbor and the holes patched

When Leveling Won't Work

Leveling only works on concrete that is still in one piece and structurally sound. A slab broken into several pieces, heaved upward by roots or frost, or crumbling at the surface needs replacement instead. Leveling also won't fix a slab that keeps moving because water keeps getting under it. We check the slab, look for the water source, and tell you plainly whether lifting it makes sense.

Gloved hand sealing a cleaned control joint in a concrete driveway with tan flexible sealant

Request a Leveling Quote

Send a photo of the sunken area and roughly how far it has dropped. Call (505) 371-4111 anytime or use the form.

Slab leveling equipment beside a sunken concrete panel next to a stucco house

Back to Rio Rancho Concrete Works for repair, replacement and new concrete.

Call (505) 371-4111Request a Quote